- Activities and Classes
- Facility Hire
- Get Involved
- About us
Your gas and electric costs are worked out by calculating how many units of energy you've used in each period. If you don't have a smart meter for your energy supply, you'll have to provide your energy company with meter readings. You should do this at least every two months to make sure your cost is accurate. If you don't, you'll get “estimate readings” and these may be higher than your actual consumption.
If you have gas central heating, you'll have two meters – one for electricity and one for your gas. Some properties with electric heating also have two meters; others may have one meter with two ‘rates’ or 'readings'.
These are usually found indoors near your fuse box.
If you have a pre-payment meter, click the blue button until you get to screen H.
For a single rate billing meter, you will have one row of numbers. You should read this left to right, including any 0’s at the beginning or end and ignoring any numbers in red or after the decimal point.
Please see the example below - this meter reading is 98832.
For heating tariffs with more than one rate (e.g. off-peak and on-peak on Economy 7 or Economy 10), you will have a meter reading for each of these rates. This is normally shown as high (on-peak) and low (off-peak) on your meter.
Comfort Plus meters have 3 different rates that you will need to provide. One is the on-peak, one is off-peak and the third is the control rate for your heating and hot water. Click the blue button to cycle through each of the meter readings which will tell you whether it’s rate 1, 2 or 3.
Gas meters are usually found outside in a white rectangular box on the wall or on the ground with a brown lid.
For a billing meter, you will have one row of numbers. You should read this from left to right, including any 0’s and ignoring numbers in red or after a decimal point.
For pre-payment meters, click the red button until you see the meter index screen.
Please see the example below - this reading is 06055.
For smart meters with a keypad, press 9 to see your reading. You’ll see ‘Volume’ first, and then the next screen will show the reading. Not all smart meters have a keypad.
If you’re unsure how to read your smart meter, contact your supplier.
Tampering with a gas or electricity meter is extremely dangerous and could cause electrocution, fire or an explosion. It is also illegal and can result in a hefty fine or even a prison sentence.
Signs that your meter may have been tampered with:
If you suspect a tampered meter, DO NOT TOUCH IT. If you smell gas, evacuate the property and phone 0800 111 999 immediately.
If the electricity supplier for the property is known they can be contacted directly. The following suppliers have published direct numbers for meter tampering:
If the electricity supplier to the property is not known, contact Scottish Power Revenue Protection or SSE Power Theft, on the numbers above.